Modulus Elastisitas Beton Geopolimer Berbasis Fly ash PLTU Tanjungjati B Jepara
DOI:
https://doi.org/10.26623/teknika.v19i1.8748Keywords:
Geopolymer concrete, elasticity modulus, compressive strengthAbstract
Beton geopolimer adalah beton yang dibuat tanpa menggunakan semen. Sebaliknya, fly ash—bahan sisa pembakaran batu bara di pembangkit listrik tenaga uap—dimanfaatkan (PLTU). Pada penelitian ini fly ash dari PLTU Tanjungjati B Jepara digunakan untuk menguji modulus elastisitas beton geopolimer sehingga diperoleh pemahaman yang jelas mengenai sifat-sifatnya. Tiga benda uji silinder 15/30 digunakan untuk menguji modulus elastisitas beton. Rata-rata modulus elastisitas beton geopolimer umur 28 hari sebesar 20.560,797 MPa. Model modulus elastisitas dan kuat tekan beton geopolimer dengan persamaan Ec = 12761 (f’c) 0,4657 diperoleh dari hasil regresi daya. Validasi dilakukan dengan korelasi, angka R2 = 0,9944 mendekati satu, artinya hubungan kuat tekan dengan modulus elastisitas sangat kuat atau valid. Nilai modulus elastisitas hasil laboratorium berbeda 0,338% dengan nilai modulus elastisitas SNI dan selisih nilai modulus elastisitas Hukum Hookes sebesar 0,018%. Grafik hasil laboratorium dan Hooke berimpit
References
Mehta, P. K., ‘Reducing the Environmental Impact of Concrete’, Concr. Int. V.23 No.10, Oct.2001, pp 61-66.
J. Davidovits, ‘Global warming impact on the cement and aggregates industries’, World Resour. Rev., 1994.
J. Davidovits, ‘Properties of Geopolymer Cements’, First Int. Conf. Alkaline Cem. Concr., pp. 131–149, 1994.
J. Davidovits, ‘Environmentally Driven Geopolymer Cement Applications’, Geopolymer 2002 Conf., no. 6, pp. 1–9, 2002.
D. NHardjito, ‘Fly ash-based geopolymer concrete’, Fly ash-based geopolymer Concr., 2005.
A. Kustirini, Antonius, and P. Setiyawan, ‘Effect of sodium hydroxide concentration on the compressive strength of geopolymer mortar using fly ash PLTU Tanjungjati B Jepara’, IOP Conf. Ser. Earth Environ. Sci., vol. 955, no. 1, 2022, doi: 10.1088/1755-1315/955/1/012010
K. . Murdock, L. J., Brook, Bahan dan Praktek Beton. erlangga jakarta, 1991.
J. C. McCormac, Desain Beton Bertulang. erlangga jakarta, 2003.
ASTM, ASTM C469-02, Standard Test Method for Static Modulus of Elasticity and Poisson’s Ratio of Concrete in Compression. ASTM International, West Conshohocken, Pa, 2019.
Badan Standarisasi Nasional, SNI 03-2847-2019 Tata Cara Perhitungan Struktur Beton Untuk Bangunan Gedung. Indonesia, 2019.
A. Antono, Teknik Beton. UGM, 1995.
T. Mulyono, Teknologi Beton. ANDI, Bandung.
Badan Standardisasi Nasional, ‘SNI 1974:2019 Cara Uji Kuat Tekan Beton Dengan Benda Uji Silinder’, 2011
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
This work is licensed under a Creative Commons Attribution 4.0 International License.
